15. Connect the power cord to the machine.
16. Set the paper tray.
17.
Turn on the main power.
18. The machine will start the initial settings automatically. This takes about 5 minutes.
19. Wait until the initial settings are terminated and “Ready” is shown on the operation panel.
• Never turn off the main power before all initial settings are terminated.
Paper Tray
1. Pull out the paper tray [A]. Then adjust the side guides and end guide to match the paper size.
• To move the side guides, first pull out the tray fully. Then push down the green lock at the rear
inside the tray.
Mainframe Installation
45
To Next Page
Loading...
