2. Turn the SD-card label face [A] of the browser unit to the rear of the machine. Then push it slowly
into slot 2 (lower) until you hear a click.
3. Plug in and turn on the main power switch.
4.
Push the "User Tools" key.
• If an administrator setting is registered for the machine, step 5 and 6 are required. Otherwise,
skip to the step 7.
5. Push the "Login/ Logout" key.
6. Login with the administrator user name and password.
7. Touch "Extended Feature Settings" twice on the LCD.
8. Touch "Uninstall" on the LCD.
9. Touch the "Browser" line.
10. Confirmation message appears on the LCD.
11. Touch "Yes" to proceed.
12. Reconfirmation message appears on the LCD.
13. Touch "Yes" to uninstall the browser unit.
14. You will see "Uninstalling the extended feature... Please wait.", and then "Completed".
15. Touch "Exit" to go back to the setting screen.
16. Exit "User/Tools" setting, and then turn off the main power switch.
17. Remove the SD card of the browser unit from SD card slot 2 (lower).
18. Overwrite the updated program in the "sdk" folder of the browser unit application with PC.
19. Do the "Installation Procedure" to install the browser unit.
Handling Firmware Update Errors
An error message shows in the first line if an error occurs during a download. The error code consists of
the letter "E" and a number ("E20", for example).
Error Message Table
Code Meaning Solution
20 Cannot map logical address Make sure the SD card is inserted correctly.
21 Cannot access memory HDD connection incorrect or replace hard disks.
22
Cannot decompress compressed
data
Incorrect ROM data on the SD card, or data is
corrupted.
Firmware Update
607
To Next Page
Loading...
Need help?
General
