9. “It is executing it” is shown on the screen while executing.
10. Wait for 2 to 3 minutes until “Completed” is shown.
• The SMC list saving may take from 2 to 3 minutes to complete.
• Press [CANCEL] to abort executing.
11.
Press [Exit] to exit from SP mode.
File Names of the Saved SMC Lists
The SMC list data saved on the SD-card will be named automatically. The file naming rules are as
follows.
Example:
A:
Machine serial number (fixed for each machine)
B:
SP number saved in this file.
First four digits (5992) in this part are fixed. The other one or two digits are the detail SP number(s). In
this case, it is one digit. Therefore, this file is of SP5-992-001 (All data list). See the upper SP table for
the correspondence between SP detail numbers and the contents.
C:
5. System Maintenance
630
To Next Page
Loading...
