001 Minimum 2: ID Sensor *ENG
[0.00 to 5.50 / - / 0.01V/step]
005 Minimum 2: Front *ENG
006 Minimum 2: Center *ENG
007 Minimum 2: Rear *ENG
2146
[TM-Sensor Test]
This SP is used to check the TM sensors.
005 Number of Edge Detection:Front *ENG
[0 to 16 / - / 1/step]006
Number of Edge
Detection:Center
*ENG
007 Number of Edge Detection:Rear *ENG
2150
[Area Mag. Correction] LD Pulse Area Correction (Color, Area) FA
Adjusts the magnification for each area. The main scan (297 mm) is divided into 13 areas.
Area 1 is at the front side of the machine (left side of the image) and area 13 is at the rear
side of the machine (right side of the image).
Decreasing a value makes the image shift to the left side on the print.
Increasing a value makes the image shift to the right side on the print.
1 pulse = 1/16 dot
027 Area 0: Bk *ENG [-16.00 to 16.00 / 0.00 / 0.01dot/step]
028 Area 1: Bk *ENG [-16.00 to 16.00 / 0.20 / 0.01dot/step]
029 Area 2: Bk *ENG
[-16.00 to 16.00 / -0.45 / 0.01dot/
step]
030 Area 3: Bk *ENG
[-16.00 to 16.00 / -0.62 / 0.01dot/
step]
031 Area 4: Bk *ENG
[-16.00 to 16.00 / -0.40 / 0.01dot/
step]
032 Area 5: Bk *ENG [-16.00 to 16.00 / 0.00 / 0.01dot/step]
033 Area 6: Bk *ENG [-16.00 to 16.00 / 0.39 / 0.01dot/step]
034 Area 7: Bk *ENG [-16.00 to 16.00 / 0.56 / 0.01dot/step]
Main SP Tables-2
87
To Next Page
Loading...
