025 ECS CTL Initializes the ECS settings.
5802
[Free Run]
Performs a free run on the copier engine.
• The machine starts free run in the same condition as the sequence of A4/LT, A3 or
A4 SEF printing from the 1st or 2nd tray. Therefore, the correct paper should be
loaded in the 1st tray or 2nd tray, but paper is not fed.
• The main switch has to be turned off and on after using the free run mode for a
test.
001
B/W A4 LEF ENG
[0 or 1 / 0 / 1/step]
0:OFF, 1:ON
002 FC A4 LEF ENG
003 FC A3 ENG
5803 [INPUT Check]
001 Registration Sensor ENG [0 or 1 / 0 / 1/step]
002 Tray Paper End Detection ENG [0 or 1 / 0 / 1/step]
003 Bypass Paper End Detection ENG [0 or 1 / 0 / 1/step]
004 Bypass paper Width Detection ENG [0 or 1 / 0 / 1/step]
006 Duplex Exit Sensor ENG [0 or 1 / 0 / 1/step]
007 Exit Sensor ENG [0 or 1 / 0 / 1/step]
008 Duplex Entrance Sensor ENG [0 or 1 / 0 / 1/step]
010 Bypass Lift Position ENG [0 or 1 / 0 / 1/step]
011 Tray Exit Sensor ENG [0 or 1 / 0 / 1/step]
012 Interlock Release Detection 1 ENG [0 or 1 / 0 / 1/step]
013 Interlock Release Detection 2 ENG [0 or 1 / 0 / 1/step]
014 Right Cover Sensor ENG [0 or 1 / 0 / 1/step]
016 ITB Contact HP Sensor ENG [0 or 1 / 0 / 1/step]
Main SP Tables-5
303
To Next Page
Loading...
