041
Fill Addr Acl Info *CTL
[- / - / -]
[Execute]
This SP must be executed immediately after installation of an HDD unit in a basic
machine that previously had no HDD. The first time the machine is powered on with the
new HDD installed, the system automatically takes the address book from the NVRAM
and writes it onto the new HDD. However, the new address book on the HDD can be
accessed only by the system administrator at this stage. Executing this SP by the service
technician immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
2.
Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
5. However, at this point the address book can be accessed by only the system
administrator or key operator.
6. Enter the SP mode and do SP5846-041. After this SP executes successfully, any
user can access the address book.
043
Addr Book Media *CTL
[0 to 30 / 4 /1/step]
0: Unconfirmed
1: SD Slot 1
2: SD Slot 2
4: USB Flash ROM
20: HDD
30: Nothing
Displays the slot number where an address book data is in.
047
Initialize Local Address Book *CTL
[- / - / -]
[Execute]
Clears the local address book information, including the user code.
048
Initialize Delivery Addr Book *CTL
[- / - / -]
[Execute]
Clears the distribution address book information, except the user code.
Main SP Tables-5
345
To Next Page
Loading...
