003 PaperTransfer:1Side:S1 *ENG
[100 to 995 / 100 / 5%/step]
004 PaperTransfer:2Side:S1 *ENG
007 PaperTransfer:1Side:S2 *ENG [100 to 995 / 150 / 5%/step]
008 PaperTransfer:2Side:S2 *ENG [100 to 995 / 160 / 5%/step]
011 PaperTransfer:1Side:S3 *ENG [100 to 995 / 150 / 5%/step]
012 PaperTransfer:2Side:S3 *ENG [100 to 995 / 270 / 5%/step]
015 PaperTransfer:1Side:S4 *ENG [100 to 995 / 200 / 5%/step]
016 PaperTransfer:2Side:S4 *ENG [100 to 995 / 435 / 5%/step]
2690
[ITB Contact Setting]
Sets the image transfer belt contact for each paper.
001 Thick1 *ENG
[0 or 1 / 0 / 1/step]
002 Thick2 *ENG
003 Thick3 *ENG
014 Special4 *ENG
015 Special5 *ENG
016 Special6 *ENG
2900 [Fus.Reload:DrumIdleTimeOffset]
001 Normal Speed *ENG
[0 to 30 / 0 / 1s/step]
003 Low Speed *ENG
2905 [Dev Rvs]
003
Time K ENG [0 to 200 / 0 / 10msec/step]
Sets the clutch on time at drum motor reverse.
005
Threshold Counter ALL ENG [0 to 400000 / 0 / 10mm/step]
Rotation threshould to determine if development roller reverse is required or not.
5. System Maintenance
398
To Next Page
Loading...
Need help?
General
