002 Lamp ON ENG [0 or 1 / 0 / 1/step] 0:OFF, 1:ON
4014
[Scan]
Execute the scanner free fun with each mode.
001 HP Detection Enable ENG [0 or 1 / 0 / 1/step] 0:OFF, 1:ON
002 HP Detection Disable ENG [0 or 1 / 0 / 1/step] 0:OFF, 1:ON
4020 [Dust Check]
001 Detection ON/OFF:face *ENG
Turns the ARDF scan glass dust check on/ off.
[0 or 1 / 0 / 1step]
0: OFF, 1: ON
002 Detection Level:face *ENG
Selects the detect level.
[0 to 8 / 4 / 1step]
0: lowest detection level
8: highest detection level
003 Correction Level:face *ENG
Selects the level of the sub scan line correction
when using the ARDF.
[0 to 4 / 0 / 1step]
0: Off
1: Weakest
2: Weak
3: Strong
4: Strongest
4400
[Scanner Erase Margin]
Sets the Mask for Original.
These SPs set the area to be masked during platen (book) mode scanning.
001 Book: Leading Edge *ENG [0.0 to 3.0 / 0.0 / 0.1mm/step]
002 Book: Trailing Edge *ENG [0.0 to 3.0 / 0.0 / 0.1mm/step]
003 Book: Left *ENG [0.0 to 3.0 / 0.0 / 0.1mm/step]
5. System Maintenance
426
To Next Page
Loading...
Need help?
General
