5121
[Counter Up Timing]
This program specifies when the counter goes up. The settings refer to “paper feed” and
“paper exit” respectively.
001 0:Feed 1:Exit *CTL [0: Feed / 1: Exit]
5127
[APS Mode]
This program disables the APS.
001 - *CTL
[0 or 1 / 0 / 1/step]
0: Not disabled 1: Disabled
5131
[Paper Size/Type Selection]
The program selects a paper size system from the following alternatives: the AB system
(0), the LT system (1), and the AF system (2).
001 - *ENG [0 :JP(Japan) / 1: NA / 2: EU/ASIA]
5162
[App. Switch Method]
This program specifies the switch that selects an application program.
001 - *CTL [0: Soft Key Set / 1: Hard Key Set]
5167
[Fax Printing Mode at Optional Counter Off]
Enables or disables the automatic print out without an accounting device. This SP is used
when the receiving fax is accounted by an external accounting device.
001
Fax Printing Mode at
Optional Counter Off
*CTL
[0 or 1 / 0 / - ]
0: Automatic printing
1: No automatic printing
5169
[CE Login]
If you will change the printer bit switches, you must ‘log in’ to service mode with this SP
before you go into the printer SP mode.
5. System Maintenance
438
To Next Page
Loading...
Need help?
General
