No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
-08 D sysarch (LPUX_ENGINE_TIMERCTRL) error
-09 D sysarch (LPUX_RETURN_FACTOR_STR) error
-10
to -12
D sysarch (LPUX_GET_PORT_INFO) error
-35 D read () error
-91
to -94
D Sub-system error
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
819
CTL
D
Fatal kernel error
[XXXX]: Detailed error code
Due to a control error, a RAM overflow occurred during system processing. One
of the following messages was displayed on the operation panel.
• System program defective
• Controller board defective
•
Optional board defective
1. Replace controller firmware
[0x6261]
HDD defective
6261 6420 6469 7200 00
"bad dir"
[0x696e]
gwinit process ending
0x69742064 "init died”
[0x766d]
VM is full
0x5f706167 "vm_pageout: VM is full”
[554c]
Processing ends at USB loader
UL (USB error)
----
Others
Error in the OS
SC Tables
673
To Next Page
Loading...
Need help?
General
