No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
[2701]
A verify error occurred when setting data was read from the clock generator via
the I2C bus.
• Defective clock generator
•
Defective I2C bus
•
Defective I2C port on the CPU
1. Replace the controller board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
839
CTL
D
USB NAND Flash ROM error
[XXXX]: Detailed error code
[9001]
USB NAND Flash ROM cannot be read.
• Defective controller board
[9101]
The ID of the USB NAND Flash ROM cannot be read.
• Defective controller board
[9110]
The USB NAND Flash ROM controller is disconnected.
• Defective controller board
1. Replace the controller board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
840
CTL
D
EEPROM error 1: EEPROM access
• During the I/O processing, a reading error occurred. The 3rd reading
failure causes this SC code.
• During the I/O processing, a writing error occurred.
•
Defective EEPROM
SC Tables
679
To Next Page
Loading...
