No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
860
CTL
D
HDD startup error at main power on
HDD is connected but a driver error is detected.
The driver does not respond to the HDD within 30 s.
• HDD is not initialized
•
Label data is corrupted
•
Defective HDD
1. Initialize the HDD with SP5832-001.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
862
CTL
D
Bad sector number error
The number of bad sectors in the HDD (image data area) goes over 101.
• Defective HDD
1. Format the HDD with SP4911-002.
2. Replace the HDD
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
863 CTL
HDD: Read error
The data written to the HDD cannot be read normally, due to bad sectors
generated during operation.
Note:
-01 to -23 indicate the type of partition where the error occurred. Enable display
of these numbers with SP7902.
• HDD defective
Note:
If the bad sectors are generated at the image partition, the bad sector information
is written to NVRAM, and the next time the HDD is accessed, these bad sectors
will not be accessed for read/write operation.
1. Turn the main power switch off and on.
2. Replace the HDD.
SC Tables
683
To Next Page
Loading...
