051
Tray3 Bank Mimimum Page
Interval: Middle Thick
*ENG [-10 to 10 / 0 / 1mm/step]
052
Tray3 Bank Mimimum Page
Interval: Thick
*ENG [-10 to 10 / 0 / 1mm/step]
1950
[Fan Cooling Time Set]
Adjust the rotation time for each fan motor after a job end.
001 Imaging Cooling Fan *ENG [0 to 600 / 0 / 1sec/step]
002 Fusing Exit Fan *ENG [0 to 600 / 10 / 1sec/step]
003 PSU Fan *ENG [0 to 600 / 0 / 1sec/step]
004 Writing Cooling Fan *ENG [0 to 600 / 0 / 1sec/step]
1951
[Fan Start Time Set]
Adjust the start time for each fan motor after a job end.
001 Imaging Cooling Fan *ENG [0 to 120 / 0 / 1sec/step]
002 Fusing Exit Fan *ENG [0 to 120 / 0 / 1sec/step]
003 PSU Fan *ENG [0 to 120 / 0 / 1sec/step]
004 Writing Cooling Fan *ENG [0 to 120 / 0 / 1sec/step]
1952
-
Specifies the time for fan control off mode.
001 Fan Control Off Mode Time Set *ENG [0 to 60 / 10 / 1min/step]
1953
[Extra Fan Control]
Configures the settings of extra fan control.
001 Cancellation Temp. Threshold *ENG [0 or 1 / - / 1/step]
006 Execution Temp. Threshold *ENG [0.0 to 100.0 / 42.0 / 0.1deg/step]
007 Cancellation Temp. Threshold *ENG [0.0 to 100.0 / 5.0 / 0.1deg/step]
3. SP Mode Tables
64
To Next Page
Loading...
