Ricoh D127 - Page 302

002 Local Port CTL
[0 or 1 / 0 / 1/step]
0: Disallow
1: Allow
5857 Save Debug Log CTL -
001
ON/OFF 0: OFF, 1: ON
Switches the debug log feature on and off. The debug log cannot be captured until this
feature is switched on.
002
Target (2: HDD 3: SD)
Selects the destination where the debugging information generated by the event selected
by SP5858 will be stored if an error is generated
[2 to 3 /1]
2: HDD
3: SD Card
005
Save to HDD
Specifies the decimal key number of the log to be written to the hard disk.
006
Save to SD Card
Specifies the debug log number for saving to an SD card.
009
Copy HDD to SD Card (Latest 4MB)
Takes the most recent 4 MB of the log written to the hard disk and copies them to the SD
Card.
A unique file name is generated to avoid overwriting existing file names on the SD Card.
Up to 4MB can be copied to an SD Card. 4 MB segments can be copied one by one to
each SD Card.
010
Copy HDD to SD Card (Latest 4MB Any Key)
Takes the log of the specified key from the log on the hard disk and copies it to the SD
Card.
A unique file name is generated to avoid overwriting existing file names on the SD Card.
Up to 4 MB can be copied to an SD Card. 4 MB segments can be copied one by one to
each SD Card. This SP does not execute if there is no log on the HDD with no key
specified.
3. Appendix: SP Mode Tables
94