0-7
Length of time that RDS is
temporarily switched on when bits
6 and 7 of System Switch 02 are
set to “User selectable”
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System Switch
02 are set to “User selectable”.
The default setting is 24 hours.
System Switch 04 [SP No. 1-101-005]
No FUNCTION COMMENTS
0-2 Not used Do not change these settings.
3
Printing dedicated tx parameters
on Quick/Speed Dial Lists
0: Disabled
1: Enabled
1: Each Quick/Speed dial number on the list is printed
with the dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated
tx parameters; 34 bytes of data are printed (the other 24
bytes have no use for service technicians).
4-7 Not used Do not change these settings.
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION COMMENTS
0
Confidential image option on the
result report
0: OFF
1: ON (Attached)
Selects images Attached/Not attached on the
accumulation/Tx result report for confidential Tx.
1
Condition selection for admin
communication report record
0: After image data Tx
1: After call connection
0: Communications that reached phase C (message
tx/rx) of the T.30 protocol are listed on the Journal.
1: communications that reached phase A (call setup) of T.
30 protocol are listed on the Journal. This will include
telephone calls.
5. Appendix: Fax Service Program
196
To Next Page
Loading...
