Ricoh D127 - Page 405

2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
3
Printing of the error code on the
error report
0: No 1: Yes
1: Error codes are printed on the error reports.
4 Not used Do not change this setting.
5
Power failure report
0: Disabled 1: Enabled
1: A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power was
turned off last.
6
Conditions for printing the protocol
dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when system switch 00
bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol dump
list only for communications with errors.
7
Priority given to various types of
remote terminal ID when printing
reports
0: RTI > CSI > Dial label > Tel.
Number
1: Dial label > Tel. number > RTI >
CSI
This bit determines which set of priorities the machine uses
when listing remote terminal names on reports.
Dial Label: The name stored, by the user, for the Quick/
Speed Dial number.
System Switch 0A [SP No. 1-101-011]
No FUNCTION COMMENTS
0-3 Not used Do not change these settings.
4 Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when the
external telephone is not by the machine, or if a wireless
telephone is connected as an external telephone.
1: The user can dial on the machine’s ten-key pad when
the handset is off-hook.
Bit Switches
197