5
JBIG compression method:
Reception
0: Only basic supported
1: Basic and optional both
supported
Change the setting when communication problems occur
using JBIG compression.
6
JBIG compression method:
Transmission
0: Basic mode priority
1: Optional mode priority
Change the setting when communication problems occur
using JBIG compression.
7
Closed User Group (CUG)
connecting ON/OFF switch (for
RX)
0: OFF
1: ON
0: All Fax received
1: Fax only from a sender machine that has the same
polling ID as the receiver, can be received.
Communication Switch 01 [SP No. 1-104-002]
No FUNCTION COMMENTS
0
ECM
0: Off 1: On
If this bit is set to 0, ECM is switched off for all
communications.
In addition, V.8 protocol and JBIG compression are
switched off automatically.
1 Not used Do not change the setting.
2-3
The trigger selection for the G3
misconnecting protection
00: OFF
01: All CSI digits un-corresponded
10: The last 4 CSI digits un-corresponded
11: CSI and RTI absence
4-5 Not used Do not change the setting.
5. Appendix: Fax Service Program
218
To Next Page
Loading...
