6-7
Maximum printable page length
available
Bit 7: 0 Bit 6: 0 = No limit
Bit 7: 0 Bit 6: 1 = B4 (364 mm)
Bit 7: 1 Bit 6: 0 = A4 (297 mm)
Bit 7: 1 Bit 6: 1 = Not used
The setting determined by these bits is informed to the
transmitting terminal in the pre-message protocol
exchange (in the DIS/NSF frames).
Communication Switch 02 [SP No. 1-104-003]
No FUNCTION COMMENTS
0
G3 Burst error threshold
0: Low 1: High
If there are more consecutive error lines in the received
page than the threshold, the machine will send a negative
response. The Low and High threshold values depend on
the sub-scan resolution, and are as follows.
100 dpi 6(L)
12(H)
200 dpi 12(L) 24(H)
300 dpi 18(L) 36(H)
400 dpi 24(L) 48(H)
1
Acceptable total error line ratio
0: 5% 1: 10%
If the error line ratio for a page exceeds the acceptable
ratio, RTN will be sent to the other end.
2
Treatment of pages received with
errors during G3 reception
0: Deleted from memory without
printing
1: Printed
0: Pages received with errors are not printed.
3
Hang-up decision when a
negative code (RTN or PIN) is
received during G3 immediate
transmission
0: No hang-up, 1: Hang-up
0: The next page will be sent even if RTN or PIN is
received.
1: The machine will send DCN and hang up if it receives
RTN or PIN.
This bit is ignored for memory transmissions or if ECM is
being used.
4-7 Not used Do not change the settings.
Bit Switches
219
To Next Page
Loading...
