7
IP Fax received telephone number
confirmation
0: No confirmation,
1: Confirmation
When "0" is selected, fax data is received without
checking the telephone number.
When "1" is selected, fax data is received only
when confirming that the telephone number from
the sender matches the registered telephone
number in this machine. If this confirmation fails, the
line is disconnected.
IP-Fax Switch 01
No. FUNCTION COMMENTS
0-3
Select IP FAX Delay Level Raise the level by selecting a higher setting if too
many transmission errors are occurring on the
network.
If TCP/UDP is enabled on the network, raise this
setting on the T.30 machine. Increasing the delay
time allows the recovery of more lost packets.
If only UDP is enabled, increase the number of
redundant packets.
Level 1 to 2: 3 Redundant packets
Level 3: 4 Redundant packets
Bit3 Bit2 Bit1 Bit0 Setting
0 0 0 0 Level 0
0 0 0 1 Level 1
0 0 1 0 Level 2
0 0 1 1 Level 3
4-7 IP Fax preamble wait time setting
Selects the preamble wait time.
[00 to 0F]
There are 16 values in this 4-bit binary switch
combination.
Waiting time: set value level x 100 ms
Max: 0F (1500 ms) Min: 00 (No wait time)
The default is "0000" (00H).
IP Fax Switch 02 [SP No. 1-111-003]
No. FUNCTION COMMENTS
Bit Switches
237
To Next Page
Loading...
