Ricoh D127 - Page 446

0
IP Fax bit signal reverse setting
0: Maker code setting
1: Internal bit switch setting
When "0" is selected, the bit signal reverse method
is decided by the maker code.
When "1" is selected, the bit signal reverse method
is decided by the internal bit switch.
(When communicating between IP Fax devices,
LSB first is selected.)
1
IP Fax transmission speed setting
0: Modem speed
1: No limitation
Selects the transmit speed for IP Fax
communication.
2
SIP transport setting
0: TCP
1: UDP
This bit switch sets the transport that has priority for
receiving IP Fax data.
This function is activated only when the sender has
both TCP and UDP.
3
CCM connection
0: No CCM connection
1: CCM connection
When "1" is selected, only the connection call
message with H.323 or no tunneled H.245 is
transmitted via CCM.
4
Message reception selection from non-
registered SIP server
0: Answer
1: Not answer
0: This answers the INVITE message from the SIP
server not registered for the machine.
1: This does not receive the INVITE message from
the SIP server not registered for the machine and
send a refusal message.
5
ECM communication setting
0: No limit for image compression
1: Limit for image compression
0: This does not limit the type of the image
compression with ECM communication.
1: When the other end machine is Ciscco, this
permits the image compression other than JBIG or
MMR with ECM communication.
6-7 Not used Do not change these settings.
IP Fax Switch 03 [SP No. 1-111-004]
No. FUNCTION COMMENTS
0
Effective field limitation for G3 standard
function information
0: OFF, 1: 4byte (DIS)
Limits the effective field for standard G3 function
information.
5. Appendix: Fax Service Program
238