5. Select the file that you want to restore from the displayed list and touch [OK].
The restoration will then begin. When the restoration is complete, a message for confirming restart
is displayed.
6. Touch [OK].
• If an error occurs during the restoration process, the settings that were restored before the error
occurred will be applied.
Synchronizing Settings on Multiple Whiteboards
Device Configuration Synchronization is a function that synchronizes the settings of the destination
whiteboard with the source whiteboard.
• Not all the settings are synchronized. For details see page 198 "Whether or not the items in
Administrator Settings can be synchronized on the multiple whiteboards".
• To synchronize settings on three or more whiteboards, specify the same source whiteboard on
each destination whiteboard. A destination whiteboard cannot be a source whiteboard for other
whiteboards.
• The synchronization setting can only be configured on the Web page of the machine.
• To configure the synchronization setting, the IP address or host name of the source whiteboard to
which to synchronize and its administrator password are required. Change the factory-set
administrator password.
• Manage the password and other information carefully to prevent the setting information from being
unintentionally leaked.
• To synchronize the information, turn the source whiteboard on.
• Information is synchronized and setting information is updated every 10 minutes.
• When synchronized, the device setting is displayed if synchronization is enabled for the device
setting and if Administrator Settings of the Web page of the machine is opened.
Procedure for making your whiteboard a source whiteboard
1. Open Administrator Settings of the Web page of the machine.
• See page 107 "Opening Administrator Settings".
2. Click [Device Configuration Management].
Managing the Device Settings
197
To Next Page
Loading...
