Ricoh FT9101 - Page 119

2.9.11 Left side blades fitting standards
1. Face the higher side of the blades to the inside.
2. The front and rear side blade brackets should be
parallel and of equal height.
3. Fit the left side blades against the fusing roller as
shown in the lower illustration.
2.9.12 Right side blades fitting standards
1. Face the higher side of the blades to the outside.
2. Fit the right side blades against the fusing roller as
shown in the lower illustration.
Left side blade
Fusing roller
Pressure roller
Left side blade
Bracket
[FRONT]
[REAR]
Right side blade
[FRONT]
[REAR]
Fusing Unit
1 July 1994
2-68