Item Description Setting Method
(10) User utility Select the finisher mode:
The sort or stack mode can be selected.
(Initial setting: Sort)
Staple in stack mode:
Stapling with the stack mode is available.
(Initial setting: No, not effective) This
function is the same as service tool utility
(4-05) 13-5-9.
Auto tray switching:
This function is the same as service tool
2-10. (Initial setting: Yes)
3-side full image copy:
A new key, beside the Check modes
key, to select the 3-side full image copy
mode can be used. This function is the
same as service tool utility (4-05) 7-5-0.
(Initial setting: No)
The 3-side full image mode is selected
at power on when "Yes" is selected with
service tool 2-09 "3-side Full Image"
Select count up or down mode:
Adding each copy or subtracting each
copy for the copy number counter can be
selected. This function is the same as
service tool 2-01. (Initial setting: Up)
Display the number of originals:
The number of originals copied in the
stack original feed mode is displayed in
the message area after copying. This
function is the same as service tool 2-11
"Original Count Display." (Initial setting:
No)
Exit originals to tray:
A new key, beside the Check modes key,
to select the original tray exit mode can
be used. When the original tray exit
mode is selected, the stack mode is
automatically selected because this
mode cannot be used with the sort mode.
This function is the same as service tool
utility (4-05) 4-1. (Initial setting: No)
Select face up/down in stack mode:
Copies made in the stack mode can be
delivered face up (image side up) to the
shift tray. (Initial setting: Face Down)
Reverse back cover sheet:
When the back cover is selected in the
cover mode, users can select to have the
image of the back cover face inside of
the copy set or outside. (Initial setting:
Yes, It faces outside.)
Copy onto slip sheets:
When copies are made in the chaptering
mode, users can be select to have the
image of the designated original copied
on the slip sheet or not. (Initial setting:
Yes)
NOTE:
For functions which can be set with both
the user utility and service tools, if the
data is changed with one, the data in the
other will be changed automatically.
Press [10] of the menu of the user tools.
⇓
Press "Yes/No", "Sort/Stack", "Up/Down",
or "Face Up/Face Down" for the
function(s) to be used.
1 July 1994 TABLE OF USER TOOLS
6-5
To Next Page