System Service Mode
M065/M066 8-36 SM Appendix
2103
[Erase Margin Adjust] (Area, Paper Size)
Adjusts the erase margin by deleting image data at the margins.
001 Lead Edge Width *ENG
[0 to 9.9 / 4.2 / 0.1 mm/step]
002 Trailing Edge Width *ENG
003 Left *ENG
[0 to 9.9 / 2 / 0.1 mm/step]
004 Right *ENG
2104
[LD Initial Power Adjust]
Adjusts the LD initial power. These SPs must be input only when a new laser
unit is installed.
001 LD1: K *ENG
[60 to 140 / 100 / 0.1 %/step]
002 LD2: K *ENG
003 LD1: C *ENG
004 LD2: C *ENG
005 LD1: M *ENG
006 LD2: M *ENG
007 LD1: Y *ENG
008 LD2: Y *ENG
2105
[LD Power Adjust] DFU
(Process Speed, Color)
Adjusts the LD power of each color for each process speed.
Each LD power setting is decided by process control.
Low: 85 mm/s, High: 260 mm/s, Middle: 182 mm/s
001 Bk: Standard Speed *ENG
[50 to 120 / 100 / 1%/step]
Decreasing a value makes lines
thinner on the output.
Increasing a value makes lines
002 C: Standard Speed *ENG
003 M: Standard Speed *ENG
To Next Page
Loading...
