System Service Mode
SM Appendix 8-165 M065/M066
Appendix:
SP Mode
Tables
2871
[Special 3: L-Edge Correct] DFU
Special 3 Paper: Leading Edge Correction
Adjusts the correction to the paper transfer roller current at the paper leading
edge in each mode. SP2852 and SP2857 are multiplied by these SP values.
Low: 85 mm/sec
The paper leading edge area can be adjusted with SP2872.
003 Paper Transfer: Low: 1st *ENG
[0 to 995 / 100 / 5%/step]
004 Paper Transfer: Low: 2nd *ENG
007 Separation DC: Low: 1st *ENG
008 Separation DC: Low: 2nd *ENG
2872
[Special 3: Sw Timing: Lead. Edge] DFU
Adjusts the bias/ voltage switch timing of the paper transfer roller/ discharge
plate at the paper leading edge between the erase margin area and the image
area.
Low: 85 mm/sec
003 Paper Transfer: Low: 1st *ENG
[0 to 50 / 0 / 2 mm/step]
004 Paper Transfer: Low: 2nd *ENG
007 Separation DC: Low: 1st *ENG
008 Separation DC: Low: 2nd *ENG
To Next Page
Loading...
