System Service Mode
M065/M066 8-180 SM Appendix
010
C-pattern: C *ENG
[0 to 255 / 5 / 1 time/step]
Specifies the belt mark generating time for checking the magenta toner density
when toner density is detected to be low at the toner density adjustment.
011
C-pattern: M *ENG
[0 to 255 / 5 / 1 time/step]
Specifies the belt mark generating time for checking the cyan toner density
when toner density is detected to be low at the toner density adjustment.
012
C-pattern: Y *ENG
[0 to 255 / 5 / 1 time/step]
Specifies the belt mark generating time for checking the yellow toner density
when toner density is detected to be low at the toner density adjustment.
013
T1 Bias: Bk *ENG
[0 to 80 / 26 / 1
A/step]
Adjusts the image transfer belt bias for Black.
014
T1 Bias: C *ENG
[0 to 80 / 22 / 1
A/step]
Adjusts the image transfer belt bias for Magenta.
015
T1 Bias: M *ENG
[0 to 80 / 22 / 1
A/step]
Adjusts the image transfer belt bias for Cyan.
016
T1 Bias: Y *ENG
[0 to 80 / 22 / 1
A/step]
Adjusts the image transfer belt bias for Yellow.
017
Developer Agitation Time *ENG
[0 to 255 / 10 / 1 sec/step]
Specifies the developer mixing time at the toner density adjustment.
018
C-Pattern: LD: DUTY: Bk *ENG
[0 to 15 / 15 / 1 /step]
Adjusts the LD duty for the toner consumption mode at the toner density
adjustment.
In toner consumption mode, toner is discharged when the detected
development gamma values (SP3611-001) exceed the target values
(SP3611-005) by more than the specified thresholds (SP3239-009).
To Next Page
Loading...
