System Service Mode
M065/M066 8-216 SM Appendix
025 Job End Area Coefficient *ENG
[0.1 to 25.5 / 1 / 0.1/step]
026 Job End Vb Coefficient *ENG
[0 to 100 / 40 / 1%/step]
027 Job End Length *ENG
[0 to 56 / 28 / 1mm/step]
028 Job End Supply *ENG
[0 to 1 / 0.45 / 0.001
mg/cm
2
/step]
029 TnCnmp: IntvlThsh *ENG
[0 to 1000 / 0 / 1 page/step]
030 TnCnmp: Counter:Bk *ENG
031 TnCnmp: Counter:FC *ENG
032 TnCnmp: IntvlThsh2 *ENG
[0 to 255 / 4 / 1 page/step]
3517
[Blade Damage Prevention]
Adjusts the threshold temperature for preventing the cleaning blade in the
transfer belt cleaning unit from being damaged. If the temperature is above this
value, toner is applied to the transfer belt at set intervals during the job to
prevent the blade from flipping over.
001 Execution Temp. Thresh *ENG
[0 to 50 / 0 / 1 deg/step]
3518 [Image Adj. Execution Flag] DFU
001 Toner End Recovery: Bk *ENG
[0 or 1 / 0 / 1/step]
0: OFF. 1: ON
002 Toner End Recovery: C *ENG
003 Toner End Recovery: M *ENG
004 Toner End Recovery: Y *ENG
005 Vsg Adjustment *ENG
006 Developer Agitation *ENG
007 Process Control *ENG
[0 to 2 / 0 / 1/step]
0: OFF. 1: ON (once), 2: ON (twice)
008 MUSIC *ENG
To Next Page
Loading...
