Ricoh M095 - Page 171

Service Menu
SM 5-31 M095/M096/M099/M100
System
Maintenance
Reference
TX Settings
Redial Interval
Sets the redial interval when Tx fails.
[5 Min/ 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times/ 3 Times/ 4 Times/ 5 Times]
Overseas Comm
Mode Settings
Overseas
Comm Mode
This sets the machine to ignore a DIS signal sent
from the called station once in a sending
operation.
[Off (Default)/ Ignore DIS Once]
Minimum Time
Length
If this setting is set to "On", the machine detects
the CNG signal after the line is connected. If it is
set to "Off", the machine detects the CNG signal
as long as the line is connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
Dial Pulse Setting Dial Pulse Type
This sets the number of pulses that are generated
during dialing.
 N: Dialing '0' generates 10 pulses --- Dialing
'9' generates 9 pulses.
 N+1: Dialing '0' generates 1 pulses --- Dialing
'9' generates 10 pulses.
 10-N: Dialing '0' generates 10 pulses ---
Dialing '9' generates 1 pulse.
Tone Signal
Settings
Tone Signal
Transmission
Time Length
Sets the tone signal transmission time length
[100 ms (Default)]
Minimum Pause
in Tone Dialing
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Attenuator For
Pseudo
RingBack tone
To the Line
Sets the attenuator for pseudo ringback tone to
the line
[0 to 15 / 10 (Default)/ 1 dB/step]
DTMF Level
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu/ -8 dBu/ -6 dBu]