Preventive Maintenance
SM Appendix 1-21 M095/M096/M099/M100
Appendix:
Specifications
1.4.2 YIELD ITEMS AND SERVICE MAINTENANCE
The machine default setting will show the messages “Replace Soon” at the near end condition
and “Replace Now” at the end condition for yield parts. However, you can select the preferred
machine action at near end and end for yield parts using SP mode “PM Parts Rep Notice” as
shown in the following table.
There are 4 settings (0 to 3):
PM Parts Rep
Notice
Sets whether to display the PM parts replacement notice and whether
to stop the engine.
0
At near end: No Notice / Not Stopped
At life end: Notice “Replace Now” / Not Stopped
1
At near end: No Notice / Not Stopped
At life end: No Notice / Not Stopped
2 (default)
At near end: Notice / Not Stopped
At life end: Notice “Replace Now” / Not Stopped
3
At near end: Notice “Replace Soon” / Not Stopped
At life end: Notice “Replace Now” / Stopped
Item Yield
Image Transfer Unit 90 K
Fusing Unit 90 K
Transfer Roller 90 K
To Next Page
Loading...
