Firmware Updating
M095/M096/M099/M100 5-42 SM
5.6.3 UPDATING THE ENGINE FIRMWARE
1. Make a folder in your computer.
2. Save the files (".bin", ".fwu", ".ini" and ".exe") in the folder.
3. Click the exe file to execute the updating program.
4. Click "Eng. F/W Update (USB or NET)" to send the engine firmware from PC to MF printer.
The "F/W Update (USB or NET)" buttons are for designer use only. Do not use these
buttons.
5. The machine makes a beep sound when starting the firmware update.
6. The image above is displayed at the PC and "Firmware update" and "Updating" are
displayed on the operation panel.
7. Then, you can close this window at your PC.
Do not turn off the machine until "Done Please reboot" is displayed in the operation
panel. Otherwise, the controller board will be damaged.
If “Done Please reboot“ does not appear, the download failed. Try again. You can also
switch from an Ethernet connection to a USB connection and see if that works. If you
still cannot download the firmware, it may be necessary to change the EGB and/or the
controller board.
If power failed during the download, try again. If you still cannot download the firmware,
it may be necessary to change the EGB and/or the controller board.
To Next Page
Loading...
