Ricoh M095 - After Servicing the Machine; Lithium Batteries (Mf Models); Releasing Plastic Latches

Before You Start
SM 4-3 M095/M096/M099/M100
Replacement
and
Adjustment
4.1.2 RELEASING PLASTIC LATCHES
Many of the parts are held in place with plastic latches. The latches break easily, so release
them carefully. To release a latch, press the hook end of the latch away from the part to which it
is latched.
4.1.3 AFTER SERVICING THE MACHINE
1. Make sure all parts that require grounding are properly grounded.
2. Make sure the interlock switch is functioning.
3. Do not leave unused solder or parts inside the machine.
4. Do not leave any tools inside the machine.
5. Make sure all wires are properly connected and routed.
6. Make sure wires are not jammed between parts of the machine.
4.1.4 LITHIUM BATTERIES (MF MODELS)
 Incorrect replacement of lithium battery(s) on the controller or on the fax unit poses risk
of explosion. Replace only with the same type or with an equivalent type recommended
by the manufacturer. Discard used batteries in accordance with the manufacturer’s
instructions.