Engine SP Mode
SM 5-19 D245/D246/D247
2side:Plai1:Lead *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-113
2side:Plai1:Trail *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-121
2side:Plai2:Image *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-122
2side:Plai2:Lead *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-123
2side:Plai2:Trail *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-131
2side:Mid:Image *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-132
2sideMid:Lead *ENG [-8 to 8 / 0 / 1 uA / step]
2-301-133
2side:Mid:Trail *ENG [-8 to 8 / 0 / 1 uA / step]
2302 [Transfer Curr Tim]
2-302-001
Lead Edge *ENG [-10 to 120 / 5 / 1 mm / step]
Sets to change the image transfer electric current position that is based on
the FGATE assert.
2-302-002
Trail Edge *ENG [-10 to 35 / 3 / 1 mm / step]
Sets to change the image transfer off position that is based on the FGATE
negation.
2303 [Transfer Clean Bi]
2-303-001
Positive *ENG [3 to 20 / 10 / 1 uA / step]
Adjusts when backside contamination occurred that is caused by reverse
polarity toner on the transfer roller or weak charging toner on the drum.
2-303-002
Negative *ENG [0 to 20 / 4 / 1 –uA / step]
Adjusts to improve the toner cleaning performance adhered on the transfer
roller due to paper jamming etc…
2-303-003
Deve Warmup - *ENG [0 to 20 / 4 / 1 –uA / step]
Adjusts to improve the toner cleaning performance at the development bias
activating.
To Next Page
Loading...
