5. Select the box to program.
When programming a new box, press [Not Programmed].
To change a box already programmed, press it, and then proceed to step 8.
6. Press [Transfer Box].
7. Enter a Box name, and then press [OK].
8. Enter a SUB Code.
To change the SUB Code, press [Clear], and then try again. To change Box name, press [Box
Name], and then repeat from step 7.
9. To program End Receivers, select a Receiving Station.
You can store five Receiving Stations.
7. Facsimile Features
408
To Next Page
Loading...
