Rigol DP832 Programming Guide

RIGOL Chapter 2 Command System
2-2 DP800 Programming Guide
:ANALyzer Commands
The :ANALyzer commands are used to set the analyzer parameters, execute analysis and query the analysis
results.
Command List
[1]
:
 :ANALyzer:ANALyze
 :ANALyzer:ENDTime
 :ANALyzer:FILE?
 :ANALyzer:MEMory
 :ANALyzer:MMEMory
 :ANALyzer:OBJect
 :ANALyzer:RESult?
 :ANALyzer:STARTTime
 :ANALyzer:VALue?
:ANALyzer:ANALyze
Syntax :ANALyzer:ANALyze
Description When receiving this command, the instrument executes the analysis operation
according to the current setting.
Explanation You can send the
:ANALyzer:RESult? command to view the analysis results.
Related
Command
:ANALyzer:RESult?
Note
[1]
: In the “Command List” in this manual, the parameters in the setting commands and the query
commands are not included and you can refer to the complete introductions of the commands in the text
according to the keyword.

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD