Rigol DP832 Programming Guide

RIGOL Chapter 2 Command System
2-56 DP800 Programming Guide
:SYSTem:COMMunicate:LAN:MAC?
Syntax :SYSTem:COMMunicate:LAN:MAC?
Description Query the MAC address.
Explanation The MAC (Media Access Control) address is also called hardware address and is
used to define the location of the network device. For a power supply, the MAC
address is unique and is usually used to recognize the instrument when assigning IP
address for the instrument. The MAC address (48 bits, namely 6 bytes) is usually
expressed in hexadecimal form, for example, 00-2A-A0-AA-E0-56.
Return Format The query returns the MAC address, for example, 00-2A-A0-AA-E0-56.
:SYSTem:COMMunicate:LAN:MANualip[:STATe]
Syntax :SYSTem:COMMunicate:LAN:MANualip[:STATe] {ON|OFF}
:SYSTem:COMMunicate:LAN:MANualip[:STATe]?
Description Enable or disable the manual IP configuration mode.
Query the status of the manual IP configuration mode.
Parameter
Name Type Range Default
{ON|OFF} Bool ON|OFF ON
Explanation  In manual IP configuration mode, users define the network parameters (such as
the IP address).
 When all the three configuration modes are set to “On”, the priority order of
parameter configuration is “DHCP”, “AutoIP” and “ManualIP”.
 The three IP configuration modes cannot all be set to “Off” at the same time.
Return Format The query returns ON or OFF.
Related
Commands
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]
:SYSTem:COMMunicate:LAN:DHCP[:STATe]

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD