Rigol DP832 Programming Guide

RIGOL Chapter 2 Command System
2-64 DP800 Programming Guide
:TIMEr:CYCLEs
Syntax :TIMEr:CYCLEs {N|I}[,<value>]
:TIMEr:CYCLEs?
Description Set the number of cycles of the timer.
Query the current number of cycles of the timer.
Parameter
Name Type Range Default
{N|I} Discrete N|I N
<value> Integer 1 to 99999 1
Explanation  The number of cycles is defined as the number of times that the instrument
performs timing output according to the preset voltage/current.
 The total number of groups in each timing output = the number of groups ×
the number of cycles; wherein, the number of groups is set by
the
:TIMEr:GROUPs command.
The power supply will terminate the timer function when the total number of groups
of outputs is finished. At this point, the state of the power supply depends on the
setting of the
:TIMEr:ENDState command.
Return Format The query returns I or N,<value>, for example, N,20.
Example :TIME:CYCLE N,20
:TIME:CYCLE?
Related
Commands
:TIMEr:ENDState
:TIMEr:GROUPs

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD