Rigol DP832 Programming Guide

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-37
:PRESet Commands
Command List:
 :PRESet[:APPLy]
 :PRESet:KEY
 :PRESet:USER[n]:SET:CURRent
 :PRESet:USER[n]:SET:DEFault
 :PRESet:USER[n]:SET:TRACk
 :PRESet:USER[n]:SET:OCP
 :PRESet:USER[n]:SET:OVP
 :PRESet:USER[n]:SET:OTP
 :PRESet:USER[n]:SET:SURE
 :PRESet:USER[n]:SET:VOLTage
Note: When [n] is omitted, the operation is performed on the user-preset state currently selected by
default.
:PRESet[:APPLy]
Syntax :PRESet[:APPLy]
Description Restore the instrument to default value or user-preset value.
Explanation
Sending this command is equivalent to pressing Preset at the front panel, namely
recalling the default value or user-preset value related to the key (depend on
the
:PRESet:KEY command).
Related
Command
:PRESet:KEY

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD