Rigol DP832 Programming Guide

RIGOL Chapter 2 Command System
2-54 DP800 Programming Guide
:SYSTem:COMMunicate:LAN:DHCP[:STATe]
Syntax
:SYSTem:COMMunicate:LAN:DHCP[:STATe] {ON|OFF}
:SYSTem:COMMunicate:LAN:DHCP[:STATe]?
Description Enable or disable the DHCP mode.
Query the status of the DHCP mode.
Parameter
Name Type Range Default
{ON|OFF} Bool ON|OFF ON
Explanation  In DHCP mode, the DHCP server in the current network assigns network
parameters (such as the IP address) for the instrument.
 When all the three configuration modes are set to “On”, the priority order of
parameter configuration is “DHCP”, “AutoIP” and “ManualIP”.
 The three IP configuration modes cannot all be set to “Off” at the same time.
Return Format The query returns ON or OFF.
Example
:SYST:COMM:LAN:DHCP ON
:SYST:COMM:LAN:DHCP?
Related
Commands
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]
:SYSTem:COMMunicate:LAN:MANualip[:STATe]
:SYSTem:COMMunicate:LAN:DNS
Syntax :SYSTem:COMMunicate:LAN:DNS <dns>
:SYSTem:COMMunicate:LAN:DNS?
Description Set the DNS (Domain Name Service).
Query the current DNS.
Parameter
Name Type Range Default
<dns>
ASCII character
string
The format is nnn.nnn.nnn.nnn;
the first nnn ranges from 1 to 223
(except 127), the other three range
from 0 to 255
None
Explanation  This command is only available when the manual IP configuration mode is
enabled.
 You are recommended to ask your network administrator for an address
available.
Return Format The query returns the DNS address, for example, 172.16.3.2.
Example :SYST:COMM:LAN:DNS 172.16.3.2
:SYST:COMM:LAN:DNS?
Related
Command
:SYSTem:COMMunicate:LAN:MANualip[:STATe]

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD