Rigol DS7024 - Chapter 14 Waveform Recording & Playing

To Next Page

To Previous Page

Chapter 14 Waveform Recording & Playing                                                                                  RIGOL 
MSO7000/DS7000 User Guide  14-1 
Chapter 14 Waveform Recording & Playing 
 
Waveform recording & playing function can play the recorded waveforms of the 
analog input channels (CH1-CH4) and the digital channels (D0-D15), enabling you to 
analyze the waveforms better.   
 
Note: The horizontal time base must be set to "YT" mode during waveform 
recording. 
 
Contents in this chapter: 
⚫  Common Settings 
⚫  Record Options 
⚫  Play Options 
 
 

Main Page

default chapter3
- Guaranty and Declaration3
- Safety Requirement4
- Safety Notices and Symbols6
- Measurement Category7
- Ventilation Requirement7
- Working Environment8
- Care and Cleaning9
- Environmental Considerations10
- MSO7000/DS7000 Series Overview11
- Document Overview12
- Table of Contents16
Chapter 1 Quick Start25
- General Inspection26
- Appearance and Dimensions27
- To Prepare for Use28
- To Adjust the Supporting Legs28
- To Connect to AC Power28
- Turn-On Checkout29
- To Replace the Fuse29
- To Connect the Probe30
- Function Inspection33
- Probe Compensation34
- Front Panel Overview35
- Rear Panel Overview36
- Front Panel Function Overview39
- Vertical39
- Horizontal40
- Wave41
- Trigger42
- Clear42
- Auto42
- Run/Stop42
- Single43
- Multifunction Knob43
- Function Menu44
- Touch Lock Key44
- Quick Key (Shortcut Key)45
- User Interface46
- Touch Screen Controls50
- Tap50
- Pinch & Stretch51
- Drag51
- Rectangle Drawing52
- Parameter Setting Method54
- To Use the Security Lock55
- To Use the Built-In Help System56
- To View the Option Information and the Option Installation57
Chapter 2 To Set the Vertical System61
- To Enable or Disable the Analog Channel62
- To Adjust the Vertical Scale63
- Vertical Expansion64
- To Adjust the Vertical Offset64
- Channel Coupling65
- Bandwidth Limit66
- Probe Ratio66
- Input Impedance67
- Waveform Invert68
- To Set the Probe69
- Passive Probe69
- Active Probe69
- Amplitude Unit70
- Channel Delay70
- Offset Cal71
- Channel Label72
Chapter 3 To Set the Horizontal System75
- To Adjust the Horizontal Time Base76
- To Adjust the Horizontal Position77
- Delayed Sweep78
Chapter 4 To Set the Sample System81
- Timebase Mode82
- YT Mode82
- XY Mode82
- ROLL Mode84
- Acquisition Mode85
- Normal85
- Average85
- Peak86
- High Resolution87
- Sampling Mode87
- Sample Rate87
- LA Sample Rate89
- Memory Depth89
- LA Memory Depth91
- Anti-Aliasing91
- Horizontal Expansion91
Chapter 5 To Trigger the Oscilloscope93
- Trigger Source94
- Trigger Level/Threshold Level95
- Trigger Mode96
- Trigger Coupling98
- Trigger Holdoff98
- Noise Rejection99
- Trigger Type100
- Edge Trigger101
- Pulse Trigger102
- Slope Trigger104
- Video Trigger107
- Pattern Trigger109
- Duration Trigger111
- Timeout Trigger114
- Runt Trigger115
- Window Trigger117
- Delay Trigger119
- Setup/Hold Trigger121
- Nth Edge Trigger124
- RS232 Trigger (Option)125
- I2C Trigger (Option)128
- SPI Trigger (Option)130
- CAN Trigger (Option)132
- Flexray Trigger (Option)135
- LIN Trigger (Option)137
- I2S Trigger (Option)139
- MIL-STD-1553 Trigger (Option)142
- Zone Trigger144
- Trigger Output Connector146
Chapter 6 Operations and Measurements147
- Math Operation148
- Addition148
- Subtraction149
- Multiplication150
- Division151
- Fft152
- AND" Operation156
- OR" Operation157
- XOR" Operation158
- NOT" Operation160
- Intg161
- Diff162
- Sqrt163
- Lg (Base 10 Exponential)164
- Exp166
- Abs167
- Low Pass168
- High Pass169
- Band Pass170
- Band Stop171
- Ax+B172
- Math Operation Label173
- Auto Measurement174
- Quick Measurement after AUTO174
- Measurement Parameter176
- Measurement Settings182
- Remove the Measurement Result185
- Statistical Function185
- All Measurement186
- Cursor Measurement186
- Manual Mode188
- Track Mode192
- XY Mode194
- Measure Mode196
Chapter 7 Digital Voltmeter (DVM) and Frequency Counter197
- Digital Voltmeter (DVM)198
- To Enable or Disable DVM Measurement198
- To Select the Measurement Source198
- To Select Measurement Mode199
- To Set the Limits199
- Frequency Counter200
- To Enable or Disable the Frequency Counter200
- To Select the Measurement Source200
- To Select the Measurement Item200
- To Set Resolution201
- To Clear Count201
- To Enable or Disable the Statistical Function201
Chapter 8 Power Analysis (Option)203
- Power Quality204
- Ripple206
Chapter 9 Histogram Analysis209
- To Enable or Disable the Histogram Function210
- To Select the Histogram Type210
- To Select the Histogram Source210
- To Set the Histogram Height211
- To Set the Histogram Range211
- To Enable or Disable the Statistical Function211
- To Reset212
Chapter 10 Digital Channel213
- To Select the Digital Channel214
- To Enable/Disable the Digital Channel214
- To Set the Threshold215
- Auto Arrangement Setting216
- To Set the Waveform Display Size216
- To Set the Label216
- Group Setting217
- Waveform Color of the Digital Channel218
Chapter 11 Protocol Decoding219
- Parallel Decoding220
- RS232 Decoding (Option)225
- I2C Decoding (Option)232
- SPI Decoding (Option)237
- LIN Decoding (Option)241
- CAN Decoding (Option)247
- Flexray Decoding (Option)251
- I2S Decoding (Option)255
- 1553B Decoding (Option)260
Chapter 12 Reference Waveform265
- To Enable Ref Function266
- To Select the Reference Channel266
- To Select the Ref Source266
- To Adjust the Ref Waveform Display266
- To Save to Internal Memory267
- To Clear the Display of the Reference Waveform267
- To View Details of the Reference Waveform267
- To Reset the Reference Waveform268
- Color Setting268
- Label Setting268
- To Export to Internal or External Memory269
- To Import from Internal or External Memory269
Chapter 13 Pass/Fail Test271
- To Enable or Disable the Pass/Fail Test Function272
- To Start or Stop the Pass/Fail Test Operation272
- To Select the Source272
- To Create a Mask273
- To Save the Mask273
- To Load a Mask273
- To Set the Output Form of the Test Results274
- To Enable or Disable the Display of the Statistics of the Test Results275
- Statistics Reset275
Chapter 14 Waveform Recording & Playing277
- Common Settings278
- Record Options279
- Play Options280
Chapter 15 Search and Navigation Function283
- Search Function284
- Navigation Function286
Chapter 16 Display Control289
- To Select the Display Type290
- To Set the Persistence Time290
- To Set the Waveform Intensity291
- To Set the Screen Grid291
- To Set the Grid Brightness292
- Scale292
- Color Grade292
- Waveform Freeze292
Chapter 17 Function/Arbitrary Waveform Generator (MSO7000 Option)293
- To Output Basic Waveforms294
- To Output Sine294
- To Output Square295
- To Output Ramp296
- To Output Pulse296
- To Output DC297
- To Output Noise297
- Sinc298
- Exp.rise298
- Exp.fall299
- Ecg299
- Gauss299
- Lorentz300
- Haversine300
- To Output the Arbitrary Waveform301
- To Load the Channel and Waveform301
- To Create the Waveform302
- To Edit Waveforms304
- Modulation305
- Fsk307
- Sweep308
- Burst310
Chapter 18 Store and Load313
- Storage System314
- Storage Type314
- Load Type316
- Internal Storage and Load316
- External Storage and Load318
- Binary Data Format (.Bin)318
- Binary Header Format319
- Disk Management321
- To Select a File Type322
- To Create a Folder322
- To Delete a File or Folder326
- To Copy and Paste a File or Folder327
- To Rename a File or Folder327
- To Clear the Internal Memory Safely327
- Factory Settings328
Chapter 19 System Utility Function Setting339
- Remote Interface Configuration340
- LAN Configuration340
- To Set Mdns343
- To Set Host Name343
- To Set the GPIB Address344
- To Set HDMI344
- USB Connection344
- System-Related345
- Beeper345
- Language345
- System Information345
- Power on345
- Power Status346
- Aux Output346
- Help346
- Self-Calibration347
- Auto Config348
- Print Setting348
- Email350
- Key Locker351
- Quick Operation351
- Self-Check355
- System Time357
- Default Option357
Chapter 20 Remote Control359
- Remote Control Via USB360
- Remote Control Via LAN364
- Remote Control Via GPIB365
Chapter 21 Troubleshooting367
Appendix A: Accessories and Options369
Chapter 22 Appendix369
Appendix B: Warranty371
- Index373

Rigol DS7024 - Chapter 14 Waveform Recording & Playing

Table of Contents

Other manuals for Rigol DS7024

Related product manuals