Rion VM-56 - Page 152

140
Serial Interface
d9 = “xxx.x” D.F. of X channel (Max hold
value)
d10 = “xxx.x” Disp. of X channel (Max hold
value)
d11 = 0 or 1 Max hold Overload information
(1: Yes, 0: No)
d12 = 0 or 1 Max hold Under-range informa-
tion
(1: Yes, 0: No)
d13 = “xxx.x” PPV of X channel (Calc value)
d14 = “xxx.x” D.F. of X channel (Calc value)
d15 = “xxx.x” Disp. of X channel (Calc value)
d16 = “xxx.x” Acc. of X channel (Calc value)
d17 = “xxx.x” C.F. of X channel (Calc value)
d18 = “xxx.x” MTVV of X channel (Calc value)
d19 = “xxx.x” VDV of X channel (Calc value)
d20 = “xxx.x” KBFT or veff,max,30 of X chan-
nel (Calc value)
(General Mode:KBFT value,
SBR Mode: veff,max,30 value)
d21 = 0 or 1 Calc Overload information
(1: Yes, 0: No)
d22 = 0 or 1 Calc Under-range information
(1: Yes, 0: No)
d23 to d44 : Y channel information
(Same format as X channel)
d45 to d66 : Z channel information
(Same format as X channel)
d67 = “xxx.x” PVS (Tri axial combine value
for PPV)
* “xxx.x” is  xed at 5 digit length. Higher digits are padded with
spaces as required.
* In Auto store mode, KBFT (veff,max,30) is output. In Manual store
mode, KBFmax (veff,max) is output.
There is no setting command