Rion VM-56 - Output Calculation Value (R)

139
Serial Interface
d20 = “xxx.x” KBFT or veff,max,30 of X
channel (Calc value)
(General Mode:KBFT value,
SBR Mode: veff,max,30 value)
d21 = 0 or 1 Calc Overload information
(1: Yes, 0: No)
d22 = 0 or 1 Calc Under-range information
(1: Yes, 0: No)
d23 to d44 : Y channel information
(Same format as X channel)
d45 to d66 : Z channel information
(Same format as X channel)
d67 = “xxx.x” PVS (Tri axial combine value
for PPV
* “xxx.x” is  xed at 5 digit length. Higher digits are padded with
spaces as required.
* In Auto store mode, KBFT (veff,max,30) is output. In Manual store
mode, KBFmax (veff,max) is output.
There is no setting command
DOD Calc
Output calculation value
Send the request command at one second interval or longer.
Request command DOD Calc?
Response data d1,d2,...,d67
Returned value d1 = “xxx.x” Acc. of X channel (Inst value)
d2 = “xxx.x” PPV of X channel (Inst value)
d3 = “xxx.x” D.F. of X channel (Inst value)
d4 = “xxx.x” Disp. of X channel (Inst value)
d5= 0 or 1 Inst Overload information
(1: Yes, 0: No)
d6= 0 or 1 Inst Under-range information
(1: Yes, 0: No)
d7 = “xxx.x” Acc. of X channel (Max hold
value)
d8 = “xxx.x” PPV of X channel (Max hold
value)