Rion VM-56 - Timer Auto Mode

62
Measurement
Timer Auto mode
With this mode, you can set the measurement start time and the measurement
end time to perform measurement between these times. By setting a “Timer
Auto Interval,” you can perform, for example, a 10-minute measurement ev-
ery hour. At the same time, instantaneous values can be saved every second.
Measurement time (actual measurement time)
set as calculation interval
Measurement
start
Data saved
in address 1
Measurement
in progress
Standby
(sleep mode)
Measurement time (actual measurement time)
set as calculation interval
Data saved
in address 1
Measurement
in progress
Standby
(sleep mode)
Measurement cycle set as
timer auto interval (observation time)
Measurement cycle set as
timer auto interval (observation time)