Rion VM-56 - Command Example

143
Serial Interface
Command example
The example of a setting by a command is shown.
Using a request command after a setting is recommended.
Basic setting
Setting the time scale of time-level display to “20s”
Time Level Time Scale, 20s
Setting the level range upper limit of X channel, Y channel and Z channel to
“10 m/s
2
”
Range X, 1
Range Y, 1
Range Z, 1
When operating auto store
Setting the Store Mode to “Auto”
Store Mode, Auto
Setting the Store Name to “0100”
Store
Name, 100
Setting the Total Measurement Time to “10min”
Measurement Time Preset Auto, 10m
Setting the Inst Store Interval to “100ms”
Inst
Store Interval, 100ms
Setting the Calculation Interval to “1min”
Calculation
Interval Preset, 1m
Measurement start / stop (store)
Measure, Start * No con rmation about overwriting.
Measure, Stop
Measurement data acquisition
DOD?