Rion VM-56 - Default Settings

75
Default Settings
The factory default settings of the unit are listed below.
Displayed channel .............................................................. Z axis
Range .................................................................................
0.001 m/s
2
to 10 m/s
2
Backlight auto off .............................................................. 30 s
Backlight brightness........................................................... 2
LCD auto off at auto store .................................................. OFF
Battery type ....................................................................... Alkaline
Index .................................................................................. 1
Eco setting ......................................................................... OFF
Store mode ......................................................................... Manual
Store name ......................................................................... 0000
Measurement time.............................................................. 10 min
Time scale of Time-Level graph ........................................ 20 s
OUTPUT ...........................................................................
AC OUT Acc. Interlock
Comparator ........................................................................ OFF
Communication interface ................................................... OFF
Baud rate ............................................................................ 38400 bps
Flow control ....................................................................... OFF
Unit. ................................................................................... OFF
Freq. weighting for Acc...................................................... Wm
Freq. Range for Vel. and Disp. (Building Damage) ............ 1 Hz to 100 Hz
Freq. Range for Vel. (Human Exposure) ............................ 1 Hz to 80 Hz
Dominate Frequency Line .................................................. No Line
Delay time ......................................................................... OFF
Standard ............................................................................. General
When you turn power to the unit on while holding down the START/STOP key,
the unit will be initialized to the above settings. When wishing to set the unit
to the factory default values, select [Menu]
[System – Read/Save Setting]
[Load Default Settings] and then press the MENU/ENTER key (see page 77).
The time, language and store data are not initialized.