Risco WisDom - Ready LED; Omit LED

WisDom User Manual
15
Ready LED
The Ready LED indicates whether or not the system's intrusion zones
are secured and ready to be set.
Condition Description
ON
All intrusion zones are secure; the system
is ready to be set.
OFF
One or more intrusion zones are not
secure, and the system is not ready to be
set. Before the system can be set, the
condition must be rectified.
-OR-
3 minutes after power is restored to the
system (if defined by your engineer).
SLOW FLASH
Indicates the system is ready to be set
while a specially designated entry/exit door
remains open.
Note:
If Blank Display is [Y], this may mean there is a fault
condition.
Omit LED
The Omit LED indicates if there are omitted zones in the system. This
LED is normally lit when Part Set mode is selected.
Condition Description
ON
At least one intrusion zone is omitted, or
Part Set mode is selected.
OFF
There are no omitted zones in Unset
mode
or the system is in Set mode
(Although there are omitted zones).