WisDom User Manual
21
Chapter 3: Local Setting and Unsetting of
the System
Setting
Setting your system causes the intrusion detectors to trigger an alarm
when violated. The setting operation will be followed by a local
message announcement (If defined).
You can set your system by code setting, in which you need to use
your user code, or you can use quick setting (without using a code)
NOTE:
If during code setting you enter a wrong user code, the keypad produces three
short beeps and “Wrong Code. Please Try Again” will be heard. In this case,
press [ ] [ ] quickly and re-enter the sequence correctly.
Before setting your system check the Ready LED. If it is lit or flashing,
the system is READY to be set. If NOT the system is NOT ready to be
set. In this case, secure or omit the violated zone(s), and then proceed.
Remember, fire protection and the protection offered by the emergency
keys are always set and always available.
Your WisDom offers the following kinds of settings:
♦ Full, page 22
♦ Partial, page 23
♦ Partition, page 24
To Next Page
Loading...
