Risco WisDom - Unsetting; Unsetting the System

26 WisDom User Manual
Unsetting
Unsetting your system causes the detectors not to trigger an alarm
when violated.
The unsetting operation will be followed by a local message
announcement (If defined).
NOTE:
If during unsetting you enter a wrong user code, the keypad produces three short
beeps and the " Wrong Code. Please try again” message will be heard. If so,
re-enter the above sequence correctly.
Your WisDom offers the following kinds of unsetting:
♦ Unsetting the System, below
♦ Partition unsetting, page 26
♦ Duress unsetting, page 26
♦ Unsetting after an Alarm, page 27
♦ Resetting after an alarm, page 28
Unsetting the System
Unsetting deactivates the partitions assigned to the specified user
code.
¾ To unset the system:
1)
Enter your user code and press
(All the partitions
assigned to the code will be unset).
A confirmation
message will be heard.
NOTE:
If outside the premises, open an "Entry" door. The WisDom beeps,
indicating that the Entry Delay time period has begun. The following
message will be heard:
"System is unsetting. Please enter your code"
Before the Entry Delay time period expires, enter your user code and
press .