Risco WisDom - Quick Key Operation; LCD Status Display; LCD Blank Display

WisDom User Manual
19
Key User Functions
♦ “Speaker off”
♦ “Speaker Level 1”
♦ “Speaker Level 2”
♦ “Speaker Level 3”
♦ “Speaker Level 4”
Quick Key Operation
The Quick Key Operation is a short effective way that helps you to
easily operate your system and quickly activate user functions, skipping
the user code. For example, to set the system, simply press the
key.
NOTE:
For quick key operation your engineer has to define quick key operation.
LCD Status Display
The LCD status display will vary depending on the number of partitions
in your system.
If your system is defined with only one partition, the LCD displays the
partition name, time and date.
If your system has 2 or 3 partitions, the LCD displays the system
name, date, time and the status of each partition. A status letter
represents the partition’s status, as follows:
S: Partition is FULL set N: Partition Not Ready
P: Partition is PARTIAL set R: Partition Ready
a: Partition in Alarm
LCD Blank Display
If defined by your engineer two minutes after the last keypad operation
the keypad will be disabled and the following display will appear on the