Risco WisDom - Acknowledge Menu

36 WisDom User Manual
NOTES:
Follow Me messages are performed only after reporting to the monitoring station
Follow Me numbers are assigned certain events for which they receive calls. The
system must be programmed to call a FM number after a specific event occurs in
order for that event to trigger the call. See page 41 for more information about
FM numbers.
You can then take the appropriate action, whether this is to inform the
authorities, or to use the Family Message Center to acknowledge the
event and remotely operate the system.
Receiving an Event Call
When you receive an event call from the system, the first thing you
must do is Speak into the telephone handset in order to acknowledge
to the system that you have received the call, and to trigger the event
announcement message.
Simply picking up the phone and saying "Hello", or in fact anything, is
enough to do this.
NOTES:
If no voice is detected, the event message will start playing 5 seconds after
phone pick up.
Interference noise on the telephone line might be recognized by the WisDom as
a phone pick up and by that start playing the event message before the phone
has been picked up by you.
Press [#] to begin playback of the event message from the beginning.
Event Announcement
After you say “Hello”, the Event announcement message is made,
informing you of a security situation in your system, for example:
“24 Oaklands Street, Intruder alarm, Ground Floor, kitchen”
The event messages can be disabled or defined for only specific
events. Your engineer performs the event announcement messages
definition.
TIPS:
To repeat the Event announcement message, press [*].
To omit the Event announcement message and go directly to the
Acknowledge menu, press [Ψ].
Acknowledge Menu
After the Event announcement message, the following list of options is
announced; some of which may require your user code authorization.