WisDom User Manual
27
Partition Unsetting
Partition unsetting enables you to unset individual partitions within a
set system.
¾ To unset partitions:
1)
Select the required partition by pressing
followed by
the partition number [1/2/3].
2)
Enter your user code and press
to confirm. A
confirmation message will be heard:
“ [Partition x] is unset “
3)
Repeat the above steps to unset other partitions
Example: To unset partition 3 with code 1234 press:
3 1-2-3-4
NOTE:
If the Set LED is flashing after unsetting, check the display for activated (alarmed)
zones before proceeding.
Duress Unsetting
If you are ever coerced into unsetting your system, you can comply with
the intruder's wishes while sending a silent duress alarm to the Alarm
Receiving Center. To do so, you must use a special duress code, which
when used, will unset the system in the regular manner, while
simultaneously transmitting the duress alarm. To use a duress code,
add 1 to the last digit of your user code, as shown in the table below:
User Code Duress Code
1-2-3-4 1-2-3-5
5-6-7-8 5-6-7-9
6-7-8-9 6-7-8-0
IMPORTANT:
Under no circumstances must the duress code be used haphazardly or without
reason. ARCs, along with Police Departments, treat duress codes very seriously
and take immediate action.
To Next Page
Loading...
